Light turns on high with pot at the maximum rate. 100K is used for protecting the pot when it is at its lowest or in the off position.
Monday, January 13, 2014
1st week W 1.8.14 Potentiometer Test
A (pot) potentiometer. There was a jumper wire placed from negative to pot. Both sides of the pot need to be bent upwards to install it. Resistors start in the middle of the pot or wiper. The LED light is then placed in from resistor to end. Another jumper wire from LED to positive power to complete the cycle.
Light turns on high with pot at the maximum rate. 100K is used for protecting the pot when it is at its lowest or in the off position.
Light turns on high with pot at the maximum rate. 100K is used for protecting the pot when it is at its lowest or in the off position.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment